41
Install Hardware Options
Field Installable printer Accessories and Options
Printer Connectivity Modules
The connectivity module’s access door must be removed prior to installing the following
options —
Accessing the Connectivity Module Slot.
• ZD420 Serial Port — Installing the Serial Port Module
• RS-232 DB-9 connector with DTE/DTC auto-switching — Serial Port Interface
• ZD420 Internal Ethernet (LAN - wired) — Installing the Internal Ethernet (LAN)
Module
• RJ-45 connector
• Fast Ethernet 10/100 auto-switching, 10Base-T, and 100Base-TX networks.
Media Handling Options
The printer’s standard bezel must be removed prior to installing the following options —
Removing the Standard Bezel.
• Label Dispenser (Peel-Off Liner and Present Label for Operator) - Installing the
Label Dispenser
• General Purpose Media Cutter — Installing the Standard Media Cutter
• Linerless Media Cutter — Installing the Linerless Media ‘Tear-Off’ Bezel
• Linerless Media ‘Tear-Off’ Label Bezel —
• Printer Resolution Upgrade Kit
s (203 dpi and 300 dpi) - Print Resolution
Upgrade Kits
• Media Roll Adapters for 38.1 mm (1.5 inches), 50.8 mm (2.0 inches), or 76.2 mm
(3.0 inches) I.D. media cores - Media Roll Core Size Adapters
Power Base Options
The ZD-Series (ZD620 and ZD420) printers are supported with power base field upgrade
kits for each the direct thermal and thermal transfer versions of these printers.
• Attached Power Supply Base (power supply included)
• Battery Power Base and Battery Pack -
Not Available until after Q2 2018.
The battery power base is designed to install like the AC Power Base
To Next Page