311
Tools
Factory Test Modes
The printer includes print modes that are intended for factory test only.
Test mode 1
Initiated by holding PAUSE button while turning ON printer power. When activated, the
printer will begin printing various test patterns used to evaluate printer performance.
Test mode 2
Initiated by holding PAUSE + FEED + CANCEL button for two seconds while printer power
is ON. When activated, the printer will begin printing various test patterns used to evaluate
printer performance.
Note • Both of these test modes will consume a considerable amount of media as the tests
are performed.
You can exit either of these test modes by pressing and holding POWER button until the
printer power is switched OFF.
To Next Page
Loading...