132
Printer Configuration Menus
TAKE LABEL
Description: Set the intensity of the label taken sensor circuit.
Important • This value is set during sensor calibration. Do not change this setting unless you
are told to do so by Zebra Technical Support or by an authorized service technician.
Acceptable values: 0
to 255
SGD command used: ezpl.take_label
Print Server web page: ViewandModifyPrinterSettings>Calibration
SENSORS
—
SENSOR TYPE
—
MEDIA/RIBBON CAL
—
PRINT INFORMATION
—
LABEL SENSOR
—
TAKE LABEL
To Next Page
Loading...