EasyManua.ls Logo

Zebra ZD620 - Installing the Linerless Media Tear-Off Bezel

Zebra ZD620
348 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
50
Install Hardware Options
Installing the Linerless Media ‘Tear-Off’ Bezel
The standard bezel must be removed and DC input power disconnected before the
Linerless Tear-Off Bezel module can be installed. See Removing the Standard Bezel.
1. Open the printer and remove replace the standard platen roller with the Linerless
platen roller. See Platen Cleaning and Replacement for a replacement procedure.
See Installing the Printhead Resolution Upgrade Kits to help you identify platen
rollers.
2. Place the Tear-Off bezel module and printer right side up with the top of the module
even with the bottom of the top cover. Center and push the module into the front of
the printer and slide it up until it stops.
3. Turn the printer upside down and attach the module to the printer with the two screws
using the Torx wrench.
Note For best printer performance, update the printer’s firmware after installing options
or immediately after the printer’s initial setup. See Updating Printer Firmware.

Table of Contents

Related product manuals