79
Printer Configuration Menus
TEAR OFF
Description: Adjusts the rest position of the media after a label is printed. The rest or stop
position sets where the tear-off point is on or between labels.
If necessary, shift the position of the media over the tear-off bar after printing.
• Lower numbers move the media into the printer by the specified number of dots
(the tear line moves closer to the edge of the label just printed).
• Higher numbers move the media out of the printer (the tear line moves closer to
the leading edge of the next label).
Accepted values: –120
to 120
Related ZPL command(s): ~TA
SGD command used: ezpl.tear_off
Print Server web page: View and Modify Printer Settings
> General Setup >
Tear Off
SETTINGS
—
DARKNESS
—
PRINT SPEED
—
MEDIA TYPE
—
PRINT METHOD
—
TEAR OFF
—
PRINT WIDTH
—
PRINT MODE
—
LABEL TOP
—
LEFT POSITION
—
REPRINT MODE
—
LABEL LENGTH MAX
—
LANGUAGE
To Next Page
Loading...