EasyManua.ls Logo

Zebra ZD620 - Removing Printer Connectivity Modules

Zebra ZD620
348 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
45
Install Hardware Options
Removing Printer Connectivity Modules
Connectivity modules can easily be removed for the purpose of reconfiguring a printer or
repair. You should not remove and replace connectivity modules as a general practice.
1. Remove the interface cable (Ethernet or Serial).
2. Remove the module access door. Push down on the top of the door with your finger
tip. This releases the latch. Pull the door away and down to remove.
3. Re-attach the interface cable to the connectivity module and secure the cable.
4. Gently pull on the interface cable that is secured to the connectivity module. Slowly
pull the module out of the printer.
5. Install a different connectivity module or re-install the connectivity module’s access
door. Align it to the bottom lip of the access opening and swing it up to snap and lock
in place.

Table of Contents

Related product manuals