Zebra ZD620 - POWER UP ACTION

89
Printer Configuration Menus
POWER UP ACTION
Description: Set the action for the printer to take during the power-up sequence.
Accepted values:
• CALIBRATE—Adjusts sensor levels and thresholds, determines the label length,
and FEEDs the media to the next web/gap.
• FEED—FEEDs the labels to the first registration point.
• LENGTH—Determines the label length using current sensor values, and FEEDs the
media to the next web/gap.
• NOMOTION—Tells the printer not to move the media. You must manually ensure
that the web is positioned correctly, or press FEED to position the next web/gap.
• SHORTCAL—Sets the media and web thresholds without adjusting sensor gain,
determines the label length, and FEEDs the media to the next web/gap.
Related ZPL command(s): ^MF
SGD command used: ezpl.power_up_action
Print Server web page: ViewandModifyPrinterSettings
>Calibration
TOOLS
—
PRINT INFORMATION
—
IDLE DISPLAY
—
POWER UP ACTION
—
HEAD CLOSE ACTION
—
LOAD DEFAULTS
—
MEDIA/RIBBON CAL
—
DIAGNOSTIC MODE
—
ZBI ENABLED?
—
RUN ZBI PROGRAM
—
STOP ZBI PROGRAM
—
CONFIG INFO TO USB
—
PRINT USB FILE
—
COPY USB FILE TO E:
—
STORE E: FILE TO USB
—
PRINT STATION
—
PASSWORD PROTECT
—
PRINT TEST FORMAT