Chapter 10 Home Networking
AX/DX/EX/PX Series User’s Guide
281
10.4 UPnP
Universal Plug and Play (UPnP) is an open networking standard that uses TCP/IP for simple peer-to-peer
network connectivity between networking devices or software applications which have UPnP enabled.
A UPnP device can dynamically join a network, obtain an IP address, advertise its services, and learn
about other devices on the network. A device can also leave a network automatically when it is no
longer in use.
See Section 10.11 on page 291 for more information on UPnP.
Note: To use UPnP NAT-T, enable NAT in the Network Setting > Broadband > Edit or Add New
WAN Interface screen.
Use the following screen to configure the UPnP settings on your Zyxel Device. Click Network Setting >
Home Networking > UPnP to display the screen shown next.
Figure 130 Network Setting > Home Networking > UPnP
IP Address Enter the IP address that you want to assign to the computer on your LAN with the MAC
address that you will also specify if you select Manual Input in the previous field.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 71 Network Setting > Home Networking > Static DHCP: Static DHCP Configuration (continued)
LABEL DESCRIPTION
To Next Page
Loading...
Need help?
General
