AX/DX/EX/PX Series User’s Guide
385
CHAPTER 20
MAC Filter
20.1 MAC Filter Overview
You can configure the Zyxel Device to permit access to clients based on their MAC addresses in the
MAC Filter screen. This applies to wired connections. Every Ethernet device has a unique MAC (Media
Access Control) address. The MAC address is assigned at the factory and consists of six pairs of
hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know the MAC addresses of
wired LAN client to configure this screen.
20.2 MAC Filter
Enable MAC Address Filter and add the host name and MAC address of a wired LAN client to the table
if you wish to allow or deny them access to your network. You can choose to enable or disable the filters
per entry; make sure that the check box under Active is selected if you want to use a filter. Select
Security > MAC Filter. The screen appears as shown.
Figure 208 Security > MAC Filter