Chapter 9 Wireless
AX/DX/EX/PX Series User’s Guide
252
9.6 WMM
Use this screen to enable WiFi MultiMedia (WMM) and WMM Automatic Power Save Delivery (APSD) in
WiFi networks for multimedia applications. WMM enhances data transmission quality, while APSD
improves power management of WiFi clients. This allows time-sensitive applications, such as voice and
videos, to run more smoothly.
Click Network Setting > Wireless > WMM to display the following screen.
Method 1 PBC Use this section to set up a WPS WiFi network using Push Button Configuration (PBC). Click this
switch to make it turn blue. Click Apply to activate WPS method 1 on the Zyxel Device.
WPS Click this button to add another WPS-enabled WiFi device (within WiFi range of the Zyxel
Device) to your WiFi network. This button may either be a physical button on the outside of a
WiFi device, or a menu button similar to the WPS button on this screen.
Note: You must press the other WiFi device’s WPS button within 2 minutes of pressing
this button.
Method 2 PIN Use this section to set up a WPS WiFi network by entering the PIN of the client into the Zyxel
Device. Click this switch to make it turn blue. Click Apply to activate WPS method 2 on the Zyxel
Device.
Register Enter the PIN of the WiFi device that you are setting up a WPS connection with and click
Register to authenticate and add the WiFi device to your WiFi network.
You can find the PIN either on the outside of the WiFi device, or by checking the WiFi device’s
settings.
Note: You must also activate WPS on that WiFi device within 2 minutes to have it
present its PIN to the Zyxel Device.
Method 3 Use this section to set up a WPS WiFi network by entering the PIN of the Zyxel Device into the
client. Click this switch to make it turn blue. Click Apply to activate WPS method 3 on the Zyxel
Device.
Release
Configuration
The default WPS status is configured.
Click this button to remove all configured WiFi and WiFi security settings for WPS connections on
the Zyxel Device.
Generate
New PIN
If this method has been enabled, the PIN (Personal Identification Number) of the Zyxel Device is
shown here. Enter this PIN in the configuration utility of the WiFi device you want to connect to
using WPS.
The PIN is not necessary when you use the WPS push-button method.
Click the Generate New PIN button to have the Zyxel Device create a new PIN.
Cancel Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
Table 62 Network Setting > Wireless > WPS (continued)
LABEL DESCRIPTION
To Next Page
Loading...
Need help?
General
