ZyXEL Communications AX Series User Manual

Chapter 20 MAC Filter
AX/DX/EX/PX Series User’s Guide
386
The following table describes the labels in this screen.
20.2.1 Add New Rule
You can choose to enable or disable the filters per entry; make sure that the check box under Active is
selected if you want to use a filter, as shown in the example below. Select Security > MAC Filter > Add
New Rule. The screen appears as shown.
Figure 209 Security > MAC Filter > Add New Rule
The following table describes the labels in this screen.
Table 130 Security > MAC Filter
LABEL DESCRIPTION
MAC Address Filter Select Enable to activate the MAC filter function.
MAC Restrict Mode Select Allow to only permit the listed MAC addresses access to the Zyxel Device. Select
Deny to permit anyone access to the Zyxel Device except the listed MAC addresses.
Add New Rule Select an existing wired LAN client from the list to add as a new entry. Select Custom if you
want to manually enter the Host Name and MAC Address.
Click the Add button to create a new entry.
Set This is the index number of the MAC address.
Active Select Active to enable the MAC filter rule. The rule will not be applied if Allow is not
selected under MAC Restrict Mode.
Host Name Enter the host name of a wired LAN client that you want to allow access to the Zyxel Device.
You can use up to 17 printable characters except [ " ], [ ` ], [ ' ], [ < ], [ > ], [ ^ ], [ $ ], [ | ], [ &
], or [ ; ]. Spaces are allowed.
MAC Address Enter the MAC address of a wired LAN client that you want to allow access to the Zyxel
Device. Enter the MAC addresses in a valid MAC address format, that is, six hexadecimal
character pairs, for example, 12:34:56:78:9a:bc.
Delete Click the Delete icon to delete an existing rule.
Cancel Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
Table 131 Security > MAC Filter > Add New Rule
LABEL DESCRIPTION
Set This is the index number of the MAC address.
Active Select Active to enable the MAC filter rule. The rule will not be applied if Allow is not
selected under MAC Restrict Mode.
Host Name Enter the host name of a wired LAN client that you want to allow access to the Zyxel
Device. You can use up to 17 printable characters except [ " ], [ ` ], [ ' ], [ < ], [ > ], [ ^
], [ $ ], [ | ], [ & ], or [ ; ]. Spaces are allowed.
MAC Address Enter the MAC addresses of a wired LAN client that you want to allow access to the
Zyxel Device in these address fields. Enter the MAC addresses in a valid MAC
address format, that is, six hexadecimal character pairs, for example,
12:34:56:78:9a:bc.

ZyXEL Communications AX Series Specifications

General

Brand	ZyXEL Communications
Model	AX Series
Category	Network Router
Language	English