Chapter 9 Wireless
AX/DX/EX/PX Series User’s Guide
254
9.7 Others Screen
Use this screen to configure advanced WiFi settings, such as additional security settings, power saving,
and data transmission settings. Click Network Setting > Wireless > Others. The screen appears as shown.
Note: This screen is not available when MPro Mesh is enabled in the Network Setting > Wireless
> MESH screen.
See Section 9.10.2 on page 261 for detailed definitions of the terms listed here.
Figure 115 Network Setting > Wireless > Others
The following table describes the labels in this screen.
Table 64 Network Setting > Wireless > Others
LABEL DESCRIPTION
Band Select a 2.4GHz or 5GHz frequency band to display the following wireless settings for the
selected band.
RTS/CTS
Threshold
Data with its frame size larger than this value will perform the RTS (Request To Send)/CTS (Clear
To Send) handshake.
Enter a value between 0 and 2347.
Fragmentation
Threshold
This is the maximum data fragment size that can be sent. Enter a value between 256 and 2346.
Output Power Set the output power of the Zyxel Device. If there is a high density of APs in an area, decrease
the output power to reduce interference with other APs. Select one of the following: 20%, 40%,
60%, 80% or 100%.