Chapter 2 Hardware
AX/DX/EX/PX Series User’s Guide
64
2.3.10 WPS Button
You can use the WPS button to quickly set up a secure WiFi connection between the Zyxel Device and a
WPS-compatible clientby adding one device at a time.
To Activate WPS
1 Make sure the POWER LED is on and not blinking.
2 Press the WPS button once within 3 seconds (see the ports panel table of each Zyxel Device model in
Section 2.3 on page 50 for more information) and release it.
3 Press the WPS button on another WPS-enabled device within range of the Zyxel Device (within 120
seconds). The WPS LED flashes green while the Zyxel Device sets up a WPS connection with the other
wireless device.
4 Once the connection is successfully made, the WPS LED will light off.
2.3.11 RESET Button
If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button to reload the factory-default configuration file. This means that you will lose all configurations
that you had previously. The password will be reset to the factory default (see the device label), and the
LAN IP address will be “192.168.1.1”.
1 Make sure the POWER LED is on (not blinking).
2 To set the device back to the factory default settings, press the RESET button for more than 5 seconds or
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the defaults
have been restored and the device restarts.
To Next Page
Loading...
Need help?
General
