Chapter 11 Routing
AX/DX/EX/PX Series User’s Guide
300
Figure 147 Network Setting > Routing > Static Route
The following table describes the labels in this screen.
11.2.1 Add or Edit Static Route
Use this screen to add or edit a static route. Click Add New Static Route in the Static Route screen, the
following screen appears. Configure the required information for a static route.
Note: The Gateway IP Address must be within the range of the selected interface in Use
Interface.
Table 79 Network Setting > Routing > Static Route
LABEL DESCRIPTION
Add New Static
Route
Click this to set up a new static route on the Zyxel Device.
# This is the number of an individual static route.
Status This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
Name This is the name of the static route.
Destination IP This parameter specifies the IP network address of the final destination. Routing is always based
on network number.
Subnet Mask/
Prefix Length
This parameter specifies the IP network subnet mask of the final destination.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same network
segment as the device's LAN or WAN port. The gateway helps forward packets to their
destinations.
Interface This is the WAN interface through which the traffic is routed.
Modify Click the Edit icon to go to the screen where you can set up a static route on the Zyxel Device.
Click the Delete icon to remove a static route from the Zyxel Device.
To Next Page
Loading...
Need help?
General
