Chapter 11 Routing
AX/DX/EX/PX Series User’s Guide
307
Figure 152 Network Setting > Routing > Policy Route: Add or Edit
The following table describes the labels in this screen.
Table 85 Network Setting > Routing > Policy Route: Add or Edit
LABEL DESCRIPTION
Active Click this switch to activate this policy route. Otherwise, click to disable.
Route Name Enter a descriptive name of this policy route. You can use up to 15 printable characters except [
" ], [ ` ], [ ' ], [ < ], [ > ], [ ^ ], [ $ ], [ | ], [ & ], or [ ; ]. Spaces are allowed.
Source IP
Address
Enter the source IP address.
Source Subnet
Mask
Enter the source subnet mask address.
Protocol Select the transport layer protocol (TCP, UDP, or None).
Source Port Enter the source port number.
Source MAC Enter the source MAC address.
Source Interface
(example: br0 or
LAN1 – LAN4)
Enter the name of the interface from which the matched traffic is sent.
WAN Interface Select a WAN interface through which the traffic is sent. You must have the WAN interfaces
already configured in the Broadband screens.
Cancel Click Cancel to exit this screen without saving.
OK Click OK to save your changes.
To Next Page
Loading...
Need help?
General
