Chapter 8 Basic Setting
GS2220 Series User’s Guide
101
C HAPTER 8
Ba sic Se tting
8.1 O ve rvie w
This chapter describes how to configure the Syste m Info , G e ne ra l Se tup, Switc h Se tup, IP Se tup, Port
Se tup, Po E Se tup, Inte rfa c e Se tup, IPv6, and Clo ud Ma na g e m e nt screens.
8.1.1 Wha t Yo u Ca n Do
• Use the Syste m Info screen (
Section 8.2 on page 101) to check the firmware version number and
monitor the Switch temperature.
• Use the G e ne ra l Se tup screen (Section 8.3 on page 103) to configure general settings such as the
system name and time.
• Use the Switc h Se tup screen (Section 8.5 on page 106) to choose your VLAN type and assign priorities
to queues.
• Use the IP Se tup screen (Section 8.6 on page 107) to configure the Switch IP address, default gateway
device, management VLAN ID, and proxy server.
• Use the Po rt Se tup screen (Section 8.7 on page 112) to configure Switch port settings.
• Use the Po E Se tup screens (
Section 8.8 on page 114) to view the current amount of power that PDs
are receiving from the Switch and set the priority levels for the Switch in distributing power to PDs. This
screen is available for PoE models only.
• Use the Inte rfa c e Se tup screens (
Section 8.9 on page 120) to configure Switch interface type and
interface ID settings.
• Use the IPv6 screens (Section 8.10 on page 121) to view IPv6 status and IPv6 configuration.
• Use the Clo ud Ma na g e m e nt screen (
Section 8.11 on page 131) to display links to Ne b ula Co ntrol
Ce nte r Disc o ve ry and Ne bula Switc h Re g istra tio n screens.
8.2 Syste m Info rma tio n
In the navigation panel, click Ba sic Se tting > Syste m Info to display the screen as shown. Use this screen
to view general system information.
To Next Page
Loading...
