Chapter 8 Basic Setting
GS2220 Series User’s Guide
112
Fig ure 88 Network Proxy Configuration Application
As of this writing, this setting only allows communication between the Switch and the NCC.
Fig ure 89 Basic Setting > IP Setup > IP Configuration > Network Proxy Configuration
The following table describes the labels in this screen.
8.7 Po rt Se tup
Use this screen to configure Switch port settings. Click Ba sic Se tting > Po rt Se tup in the navigation panel
to display the configuration screen.
Table 32 Basic Setting > IP Setup > IP Configuration > Network Proxy Configuration
LABEL DESC RIPTIO N
Active Select this option to enable communication between the Switch and NCC through a proxy
server.
Server Enter the IP address (dotted decimal notation) or host name of the proxy server. When entering
the host name, up to 128 alphanumeric characters are allowed for the Se rve r including special
characters inside the square quotes [~!@#$%^&*()_+{}|:”<>?–=[]\;’,./‘]
Port Enter the port number of the proxy server (1 – 65535).
Authentication Select this option to enable proxy server authentication using a Use rna m e and Pa ssword.
Username Enter a login user name from the proxy server administrator. Up to 32 alphanumeric characters
are allowed for the Use rna me including special characters inside the square quotes
[~!@#$%^&*()_+{}|:”<>?–=[]\;’,./‘].
Password Enter a login password from the proxy server administrator. Up to 32 alphanumeric characters
are allowed for the Pa ssword including special characters except [ ? ], [ | ], [ ' ], or [ " ].
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click C a nc e l to reset the fields to your previous configuration.
To Next Page
Loading...
