Chapter 61 Switching
GS2220 Series User’s Guide
486
The following table describes the related labels in this screen.
61.9 VLAN Po rt Se tting
Use this screen to configure the static VLAN (IEEE 802.1Q) settings on a port. Click the VLAN Port Se tting
tab in the VLAN screen.
Table 255 Switching > VLAN > Static VLAN > Add or Edit Static VLAN
LABEL DESCRIPTIO N
ACTIVE Select this switch to activate the VLAN settings.
Name Enter a descriptive name for the VLAN group for identification purposes. This name consists of up
to 64 printable characters. Spaces are allowed.
VLAN Group ID Enter the VLAN ID for this static entry; the valid range is between 1 and 4094.
Port The port number identifies the port you are configuring.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Control Select Norm a l for the port to dynamically join this VLAN group. This is the default selection.
Select Fixe d for the port to be a permanent member of this VLAN group.
Select Fo rbidde n if you want to prohibit the port from joining this VLAN group.
Tagging Select TX Ta g g ing if you want outgoing traffic to contain this VLAN tag.
Otherwise, to ensure that VLAN-unaware devices (such as computers and hubs) can receive
frames properly, clear the TX Ta g g ing check box to set the Switch to remove VLAN tags before
sending.
Add/Edit Click Add or Edit to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Clear Click Cle a r to reset the fields to the factory defaults.
Cancel Click Ca nc e l to change the fields back to their last saved values.
To Next Page
Loading...
