Chapter 60 Port
GS2220 Series User’s Guide
465
C HAPTER 60
Po rt
60.1 Wha t You C a n Do
• Use the Po E Sta tus screen (
Section 60.2 on page 465) to view the current amount of power that PDs
are receiving from the Switch.
• Use the Po E Se tup screen (Section 60.3 on page 467) to set the PoE power management mode,
priority levels, power-up mode and the maximum amount of power for the connected PDs.
• Use the Po rt Se tup screen (Section 60.4 on page 469) to configure Switch port settings.
60.2 Po E Sta tus
A powered device (PD) is a device such as an access point or a switch, that supports PoE (Power over
Ethernet) so that it can receive power from another device through an Ethernet port.
You can also set priorities so that the Switch is able to reserve and allocate power to certain PDs.
Note: The PoE (Power over Ethernet) devices that supply or receive power and their
connected Ethernet cables must all be completely indoors.
Fig ure 352 PoE Example Application
To view the current amount of power that PDs are receiving from the Switch, click Po rt > Po E Se tup > Po E
Sta tus.
To Next Page
Loading...
