Chapter 61 Switching
GS2220 Series User’s Guide
474
• Use the Link Ag g re g a tion Se tting screen (Section 61.4 on page 475) to configure to enable static link
aggregation.
• Use the Link Ag g re g a tion Co ntro l Pro to c o l screen (Section 61.5 on page 477) to enable Link
Aggregation Control Protocol (LACP).
61.3 Link Ag g re g a tio n Sta tus
Use the Link Ag g re g a tio n Sta tus screen to view ports you have configured to be in the trunk group, ports
that are currently transmitting data as one logical link in the trunk group and so on.
Click Switc hing > Link Ag g re g a tio n > Link Ag g re g a tio n Sta tus in the navigation panel.
Fig ure 358 Switching > Link Aggregation > Link Aggregation Status
The following table describes the labels in this screen.
Table 248 Switching > Link Aggregation > Link Aggregation Status
LABEL DESC RIPTIO N
Group ID This field displays the group ID to identify a trunk group, that is, one logical link containing multiple
ports.
Enabled Ports These are the ports you have configured in the Link Ag g re g a tio n screen to be in the trunk group.
The port numbers displays only when this trunk group is activated and there is a port belonging to
this group.
Synchronized
Ports
These are the ports that are currently transmitting data as one logical link in this trunk group.
Aggregator ID Link Aggregator ID consists of the following: system priority, MAC address, key, port priority and
port number.
The ID displays only when there is a port belonging to this trunk group and LACP is also enabled
for this group.
To Next Page
Loading...
