Chapter 24 Multicast
GS2220 Series User’s Guide
238
24.4.4 MLD Sno o ping - pro xy Filte ring
Use this screen to configure the Switch’s MLD filtering settings. Click the Filte ring link in the Adva nc e d
Applic a tio n > Multic a st > IPv6 Multic a st > MLD Snooping - pro xy screen to display the screen as shown.
Fig ure 182 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
The following table describes the fields in the above screen.
Leave Timeout Enter the MLD snooping normal leave timeout (in milliseconds) the Switch uses to update
the forwarding table for the specified downstream ports.
This defines how many seconds the Switch waits for an MLD report before removing an
MLD snooping membership entry (learned on a downstream port) when an MLD Done
message is received on this port from a host.
Fast Leave Timeout Enter the fast leave timeout (in milliseconds) for the specified downstream ports.
This defines how many seconds the Switch waits for an MLD report before removing an
MLD snooping membership entry (learned on a downstream port) when an MLD Done
message is received on this port from a host.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Sa ve link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Ca nc e l to reset the fields to your previous configuration.
Table 104 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > VLAN > Port Role
Setting (continued)
LABEL DESC RIPTION
Table 105 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
LABEL DESCRIPTIO N
Active Select this option to enable MLD filtering on the Switch.
Port This field displays the port number.
To Next Page
Loading...
