Chapter 47 Access Control
GS2220 Series User’s Guide
401
C HAPTER 47
Ac c e ss C o ntrol
47.1 Ac c e ss Co ntrol O ve rvie w
This chapter describes how to control access to the Switch.
A console port and FTP are allowed one session each, Telnet and SSH share nine sessions, up to five web
sessions (five different user names and passwords) and/or limitless SNMP access control sessions are
allowed.
A console port access control session and Telnet access control session cannot coexist when multi-login
is disabled. See the CLI Reference Guide for more information on disabling multi-login.
47.1.1 Wha t You C a n Do
• Use the Ac c e ss Contro l screen (
Section 47.2 on page 401) to display the main screen.
• Use the SNMP screen (
Section 47.3 on page 402) to configure your SNMP settings.
• Use the Tra p G roup screen (
Section 47.3.1 on page 403) to specify the types of SNMP traps that should
be sent to each SNMP manager.
• Use the Use r Info rm a tio n screen (Section 47.3.3 on page 405) to create SNMP users for authentication
with managers using SNMP v3 and associate them to SNMP groups.
• Use the Lo g ins screens (Section 47.4 on page 407) to assign which users can access the Switch
through Web Configurator at any one time.
• Use the Se rvic e Ac c e ss Contro l screen (Section 47.5 on page 409) to decide what services you may
use to access the Switch.
• Use the Re mote Ma na g e m e nt screen (Section 47.6 on page 410) to specify a group of one or more
“trusted computers” from which an administrator may use a service to manage the Switch.
47.2 Ac c e ss Co ntrol Ma in Se tting s
Use this screen to display the main screen.
Click Ma na g e me nt > Ac c e ss C ontro l in the navigation panel to display the main screen as shown.
Table 209 Access Control Overview
Console Port SSH Telnet FTP Web SNMP
One session Share up to 9 sessions One session Up to 5 accounts No limit
To Next Page
Loading...
