Chapter 47 Access Control
GS2220 Series User’s Guide
404
Fig ure 310 Management > Access Control > SNMP > Trap Group
The following table describes the labels in this screen.
47.3.2 Ena ble or Disa ble Se nding o f SNMP Tra ps on a Po rt
From the SNMP > Tra p G ro up screen, click Po rt to view the screen as shown. Use this screen to set
whether a trap received on the ports would be sent to the SNMP manager.
Table 212 Management > Access Control > SNMP > Trap Group
LABEL DESC RIPTIO N
Trap Destination IP Select one of your configured trap destination IP addresses. These are the IP addresses of the
SNMP managers. You must first configure a trap destination IP address in the SNMP Se tting
screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Type Select the categories of SNMP traps that the Switch is to send to the SNMP manager.
Options Select the individual SNMP traps that the Switch is to send to the SNMP station.
The traps are grouped by category. Selecting a category automatically selects all of the
category’s traps. Clear the check boxes for individual traps that you do not want the Switch
to send to the SNMP station. Clearing a category’s check box automatically clears all of the
category’s trap check boxes (the Switch only sends traps from selected categories).
Apply Click Ap ply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Ca nc e l to begin configuring this screen afresh.
To Next Page
Loading...
