GS2220 Series User’s Guide
450
C HAPTER 57
Po rt Sta tus
57.1 O ve rvie w
This chapter introduces the port status screens.
57.2 Po rt Sta tus
This screen displays a port statistical summary with links to each port showing statistical details. To view
the port statistics, click Sta tus in all Web Configurator screens and then the Port Sta tus link in the Quic k
Links section of the Sta tus screen to display the Po rt Sta tus screen as shown next. You can also click
Ma na g e m e nt > Po rt Sta tus to see the following screen.
Fig ure 342 Port Status
The following table describes the labels in this screen.
Table 236 Management > Port Status
LABEL DESCRIPTIO N
Port This identifies the Ethernet port. Click a port number to display the Po rt De ta ils screen.
Name This is the name you assigned to this port in the Ba sic Se tting > Po rt Se tup screen.
Link This field displays the speed (either 10M for 10 Mbps, 100M for 100 Mbps, or 1G for 1 Gbps) and
the duplex (F for full duplex or H for half). It also shows the cable type (Co ppe r or Fib e r) for the
combo ports. This field displays Down if the port is not connected to any device.
State If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port.
If STP is disabled, this field displays FO RWA RDING if the link is up, otherwise, it displays STOP.
When LACP (Link Aggregation Control Protocol) and STP are in blocking state, it displays
Blo c king .
To Next Page
Loading...
