ZyXEL Communications GS2220 Series - Spanning Tree Protocol Status; Spanning Tree Configuration

Chapter 13 Spanning Tree Protocol
GS2220 Series User’s Guide
164
13.2 Spa nning Tre e Pro to c o l Sta tus
The Spanning Tree Protocol status screen changes depending on what standard you choose to
implement on your network. Click Adva nc e d Applic a tio n > Spa nning Tre e Pro to c ol to see the screen as
shown.
Fig ure 132 Advanced Application > Spanning Tree Protocol
This screen differs depending on which STP mode (RSTP, MRSTP or MSTP) you configure on the Switch. This
screen is described in detail in the section that follows the configuration section for each STP mode.
Click Co nfig ura tio n to activate one of the STP standards on the Switch.
13.3 Spa nning Tre e Co nfig ura tio n
Use the Spa nning Tre e C o nfig ura tio n screen to activate one of the STP modes on the Switch. Click
Config ura tio n in the Adva nc e d Applic a tio n > Spa nning Tre e Pro to c o l.
Fig ure 133 Advanced Application > Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
Table 65 Advanced Application > Spanning Tree Protocol > Configuration
LABEL DESC RIPTIO N
Spanning Tree
Mode
You can activate one of the STP modes on the Switch.
Select Ra pid Spa nning Tre e , Multiple Ra pid Spa nning Tre e or Multiple Spa nning Tre e .
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click C a nc e l to begin configuring this screen afresh.