Chapter 28 ARP Inspection
GS2220 Series User’s Guide
281
28.5 IPv6 Sta tic Binding Se tup
Use this screen to manually create an IPv6 source guard binding table entry and manage IPv6 static
bindings. Static bindings are uniquely identified by the source IPv6 address / prefix. Each source IPv6
address / prefix can only be in one static binding. If you try to create a static binding with the same
source IPv6 address / prefix as an existing static binding, the new static binding replaces the original
one. To open this screen, click Advanc e d Applic a tio n > IP Sourc e G ua rd > IPv6 Sta tic Binding Se tup.
Fig ure 211 Advanced Application > IP Source Guard > IPv6 Static Binding Setup
The following table describes the labels in this screen.
Table 133 Advanced Application > IP Source Guard > IPv6 Static Binding Setup
LABEL DESCRIPTIO N
IPv6 Static Binding
Source Address Enter the IPv6 address or IPv6 prefix and prefix length in the binding.
MAC Address Enter the source MAC address in the binding. If this binding does not check this field, select
Any.
Note: You cannot choose Any for all three of MAC Addre ss, VLAN and Po rt. You
must fill in at least one.
VLAN Enter the source VLAN ID in the binding. If this binding does not check this field, select Any.
Port Specify the ports in the binding. If this binding has one port, select the first radio button and
enter the port number in the field to the right.
Add Click this to create the specified static binding or to update an existing one.
Cancel Click this to reset the values above based or if not applicable, to clear the fields above.
Clear Click this to clear the fields above.
Index This field displays a sequential number for each binding.
Source Address This field displays the IPv6 address or IPv6 prefix and prefix length in the binding.
MAC Address This field displays the source MAC address in the binding. If the entry is blank, this field will not
be checked in the binding.
VLAN This field displays the source VLAN ID in the binding. If the entry is blank, this field will not be
checked in the binding.
Port This field displays the port number in the binding. If this field is blank, the binding applies to all
ports.
To Next Page
Loading...
Need help?
General
