ZyXEL Communications GS2220 Series - OAM Remote Loopback

Chapter 39 OAM
GS2220 Series User’s Guide
353
39.4 O AM Re m o te Lo o pba c k
Use this screen to perform a remote loopback test. In the O AM Sta tus screen click Re mo te Lo o pba c k to
display the screen as shown.
Fig ure 266 Advanced Application > OAM > OAM Remote Loopback
The following table describes the fields in the above screen.
Table 181 Advanced Application > OAM > OAM Remote Loopback
LABEL DESC RIPTIO N
Remote Loopback Test
Port Enter the number of the port from which the Switch performs a remote-loopback test.
Number of Packet Define the allowable packet number of the loopback test frames.
Packet Size Define the allowable packet size of the loopback test frames.
Test Click Te st to begin the test.
Remote Loopback Mode
Port Enter the number of the port from which the Switch sends loopback control PDUs to initiate
or terminate a remote-loopback test.
Start Click Sta rt to initiate a remote-loopback test from the specified port by sending Enable
Loopback Control PDUs to the remote device.
Stop Click Stop to terminate a remote-loopback test from the specified port by sending Disable
Loopback Control PDUs to the remote device.