Chapter 36 Link Layer Discovery Protocol (LLDP)
GS2220 Series User’s Guide
335
36.8 LLDP- MED Ne two rk Polic y
Click Adva nc e d Applic a tio n > LLDP > LLDP- MED Ne twork Po lic y (Clic k He re ) to display the screen as
shown next.
Fig ure 255 Advanced Application > LLDP > LLDP-MED Network Policy
The following table describes the labels in this screen.
MED TLV Setting
Location Select to enable transmitting LLDP-MED location TLV.
Network Policy Select to enable transmitting LLDP-MED Network Policy TLV.
Apply Click Apply to save the changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click C a nc e l to begin configuring this screen afresh.
Table 169 Advanced Application > LLDP > LLDP-MED Configuration
LABEL DESC RIPTIO N
Table 170 Advanced Application > LLDP > LLDP-MED Network Policy
LABEL DESC RIPTIO N
Port Enter the port number to set up the LLDP-MED network policy.
Application Type Select the type of application used in the network policy.
• voic e
• voic e - sig na ling
•guest-voice
• g ue st- voic e - sig na ling
• so ftphone - vo ic e
• vide o - c onfe re nc ing
• stre a ming - vid e o
• vide o- sig na ling
Tag Select to tag or untag in the network policy.
•tagged
• untagged
VLAN Enter the VLAN ID number. It should be from 1 to 4094. For priority tagged frames, enter “0”.
To Next Page
Loading...
