Chapter 30 VLAN Mapping
GS2220 Series User’s Guide
293
30.2 Ena ble VLAN Ma pping
Click Adva nc e d Applic a tio n and then VLAN Ma pping in the navigation panel to display the screen as
shown.
Fig ure 224 Advanced Application > VLAN Mapping
The following table describes the labels in this screen.
30.2.1 VLAN Ma pping C o nfig ure
Click the VLAN Ma pping C o nfig ure link in the VLAN Ma pping screen to display the screen as shown. Use
this screen to enable and edit the VLAN mapping rules.
Table 140 Advanced Application > VLAN Mapping
LABEL DESC RIPTIO N
Active Select this option to enable VLAN mapping on the Switch.
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this check box to enable the VLAN mapping feature on this port. Clear this check box to
disable the VLAN mapping feature.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Ca nc e l to begin configuring this screen afresh.
To Next Page
Loading...
