Chapter 46 Maintenance
GS2220 Series User’s Guide
392
After the process is complete, see the Syste m Info screen to verify your current firmware version number.
46.4 Re sto re Co nfig ura tio n
Use this screen to restore a previously saved configuration from your computer to the Switch.
Fig ure 301 Management > Maintenance > Restore Configuration
Type the path and file name of the configuration file you wish to restore in the File Pa th text box or click
Choose File or Bro wse to locate it. After you have specified the file, click Re sto re . "config" is the name of
the configuration file on the Switch, so your backup configuration file is automatically renamed when
you restore using this screen.
Table 203 Management > Maintenance > Firmware Upgrade
LABEL DESC RIPTION
Name This is the name of the Switch that you are configuring.
Version The Switch has 2 firmware sets, Firm wa re 1 and Firm wa re 2, residing in flash.
• Running shows the version number (and model code) and MM/DD/YYYY creation date
of the firmware currently in use on the Switch (Firmwa re 1 or Firm wa re 2). The firmware
information is also displayed at System Information in Basic Setting.
• Firm wa re 1 shows its version number (and model code) and MM/DD/YYYY creation
date.
• Firm wa re 2 shows its version number (and model code) and MM/DD/YYYY creation
date.
Current Boot Image This displays which firmware is currently in use on the Switch (Firmwa re 1 or Firm wa re 2).
Config Boot Image Select which firmware (Firm wa re 1 or Firm wa re 2) should load, click Apply and reboot the
Switch to see changes, you will also see changes in the Curre nt Bo o t Im a g e field above as
well.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Ca nc e l to begin configuring this screen afresh.
Firmware Choose to upload the new firmware to (Firmware) 1 or (Firmware) 2.
File Path Type the path and file name of the firmware file you wish to upload to the Switch in the File
Pa th text box or click Cho o se File or Bro wse to locate it.
Upgrade Click Upg ra de to load the new firmware. s are only applied after a reboot. To reboot, go to
Ma na g e me nt > Ma inte na nc e > Re b o o t Syste m and click C o nfig 1, Co nfig 2 or Fa c to ry
De fa ult (C onfig 1, C onfig 2 and Fa c tory De fa ult are the configuration files you want the
Switch to use when it restarts).
To Next Page
Loading...
