ZyXEL Communications GS2220 Series - Attributes Used for Accounting

Chapter 25 AAA
GS2220 Series User’s Guide
256
– This value is set to Ethe rne t(15) on the Switch.
Calling-Station-Id
Frame-MTU
EAP-Message
State
Message-Authenticator
25.6.4 Attribute s Use d fo r Ac c o unting
The following sections list the attributes sent from the Switch to the RADIUS server when performing
authentication.
25.6.4.1 Attribute s Use d fo r Ac c o unting Syste m Eve nts
NAS-IP-Address
NAS-Identifier
Acct-Status-Type
Acct-Session-ID
– The format of Acct-Session-Id is da te +tim e +8- dig it se q ue ntia l num b e r, for example,
2007041917210300000001. (date: 2007/04/19, time: 17:21:03, serial number: 00000001)
Acct-Delay-Time
25.6.4.2 Attribute s Use d fo r Ac c o unting Exe c Eve nts
The attributes are listed in the following table along with the time that they are sent (the difference
between Console and Telnet/SSH Exec events is that the Telnet/SSH events utilize the Calling-Station-Id
attribute):
Table 115 RADIUS Attributes – Exec Events through Console
ATTRIBUTE START INTERIM- UPDATE STO P
User-Name
 
NAS-Identifier
 
NAS-IP-Address
 
Service-Type
 
Acct-Status-Type
 
Acct-Delay-Time
 
Acct-Session-Id
 
Acct-Authentic
 
Acct-Session-Time

Acct-Terminate-Cause

Table 116 RADIUS Attributes – Exec Events through Telnet/SSH
ATTRIBUTE START INTERIM- UPDATE STO P
User-Name
 
NAS-Identifier
 
NAS-IP-Address
 