Chapter 9 VLAN
GS2220 Series User’s Guide
151
9.12 Po rt- Ba se d VLAN Se tup
Port-based VLANs are VLANs where the packet forwarding decision is based on the destination MAC
address and its associated port.
Port-based VLANs require allowed outgoing ports to be defined for each port. Therefore, if you wish to
allow two subscriber ports to talk to each other, for example, between conference rooms in a hotel, you
must define the egress (an egress port is an outgoing port, that is, a port through which a data packet
leaves) for both ports.
Port-based VLANs are specific only to the Switch on which they were created.
Note: When you activate port-based VLAN, the Switch uses a default VLAN ID of 1. You
cannot change it.
Note: In screens (such as IP Se tup and Filte ring ) that require a VID, you must enter 1 as the VID.
The port-based VLAN setup screen is shown next. The CPU management port forms a VLAN with all
Ethernet ports.
9.12.1 Co nfig ure a Po rt- Ba se d VLAN
Select Po rt Ba se d as the VLAN Type in the Ba sic Se tting > Switc h Se tup screen and then click Adva nc e d
Applic a tio n > VLAN from the navigation panel to display the next screen.
Cancel Click Ca nc e l to clear the fields in the vendor ID based VLAN entry.
Index This field displays the index number of the vendor ID based VLAN entry.
Name This field displays the name of the vendor ID based VLAN entry.
MAC Address This field displays the source MAC address that is bind to the vendor ID based VLAN entry.
Mask This field displays the mask for the source MAC address that is bind to the vendor ID based
VLAN entry.
VLAN This field displays the VLAN ID of the vendor ID based VLAN entry.
Priority This field displays the priority level which is assigned to frames belonging to this vendor ID
based VLAN.
Weight This field displays the weight of the vendor ID based VLAN entry.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Delete Click De le te to remove the selected entry from the summary table.
Cancel Click Ca nc e l to clear the check boxes.
Table 58 Advanced Application > VLAN > VLAN Configuration > Vendor ID Based VLAN Setup
LABEL DESC RIPTIO N
To Next Page
Loading...
Need help?
General
