ZyXEL Communications GS2220 Series - Port Utilization

Chapter 57 Port Status
GS2220 Series User’s Guide
456
57.2.4 Po rt Utiliza tio n
This screen displays the percentage of actual transmitted or received frames on a port as a percentage
of the Link speed. To view port utilization, click Ma na g e me nt > Po rt Sta tus > Po rt Utiliza tio n to see the
following screen. Alternatively, click Sta tus from any Web Configurator screen and then the Po rt Sta tus
link in the Quic k Links section of the Sta tus screen to display the Po rt Sta tus screen and then click the
Utiliza tio n link tab.
Fig ure 346 Management > Port Status > Utilization
The following table describes the labels in this screen.
Current This displays the current status for each monitored DDMI parameter.
High Alarm
Threshold
This displays the high value alarm threshold for each monitored DDMI parameter. An alarm
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
High Warn
Threshold
This displays the high value warning threshold for each monitored DDMI parameter. A warning
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
Low Warn
Threshold
This displays the low value warning threshold for each monitored DDMI parameter. A warning
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
Low Alarm
Threshold
This displays the low value alarm threshold for each monitored DDMI parameter. An alarm
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
Table 239 Management > Port Status > DDMI > DDMI Details (continued)
LABEL DESC RIPTIO N
Table 240 Management > Port Status > Utilization
LABEL DESC RIPTIO N
Port This identifies the Ethernet port.
Link This field displays the speed (either 10M for 10 Mbps, 100M for 100 Mbps, or 1G for 1 Gbps) and the
duplex (F for full duplex). It also shows the cable type (Co pp e r or Fibe r) for the combo ports. This
field displays Down if the port is not connected to any device.
Tx kB/s This field shows the transmission speed of data sent on this port in kilobytes per second.
Tx Utilization% This field shows the percentage of actual transmitted frames on this port as a percentage of the
Link speed.
Rx KB/s This field shows the transmission speed of data received on this port in kilobytes per second.
Rx Utilization% This field shows the percentage of actual received frames on this port as a percentage of the Link
speed.