Chapter 47 Access Control
GS2220 Series User’s Guide
410
47.6 Re mo te Ma na g e me nt
Use this screen to specify a group of one or more “trusted computers” from which an administrator may
use a service to manage the Switch.
Click Ma na g e me nt > Ac c e ss C ontro l > Re m o te Ma na g e m e nt to view the screen as shown next.
Click Ac c e ss Co ntro l to return to the Ac c e ss Co ntro l screen.
Fig ure 315 Management > Access Control > Remote Management
The following table describes the labels in this screen.
Apply Click Ap ply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Ca nc e l to begin configuring this screen afresh.
Table 216 Management > Access Control > Service Access Control (continued)
LABEL DESC RIPTIO N
Table 217 Management > Access Control > Remote Management
LABEL DESCRIPTIO N
Entry This is the client set index number. A “client set” is a group of one or more “trusted computers”
from which an administrator may use a service to manage the Switch.
Active Select this check box to activate this secured client set. Clear the check box if you wish to
temporarily disable the set without deleting it.
Start Address
End Address
Configure the IP address range of trusted computers from which you can manage this Switch.
The Switch checks if the client IP address of a computer requesting a service or protocol matches
the range set here. The Switch immediately disconnects the session if it does not match.
To Next Page
Loading...
