ZyXEL Communications GS2220 Series - Reboot System

Chapter 64 Maintenance
GS2220 Series User’s Guide
513
64.4 Re bo o t Syste m
Re bo o t Syste m allows you to restart the Switch without physically turning the power off. It also allows you
to load the C urre nt C o nfig ura tio n, a C usto m De fa ult or the Fa c to ry De fa ult configuration when you
reboot. Follow the steps below to reboot the Switch.
Click Ma inte na nc e > Ma inte na nc e > Re b o o t Syste m to view the screen as shown next.
Fig ure 388 Maintenance > Maintenance > Reboot System
1 In the Re boot Syste m screen, click a configuration button next to Re bo o t Syste m with to reboot and load
that configuration file. The following screen displays.
If you select Curre nt C o nfig ura tio n, make sure to save the Switch
settings as the current configuration in
the Ma inte na nc e > Ma inte na nc e > Sa ve Co nfig ura tio n screen.
Fig ure 389 Reboot System: Use the Current Configuration Confirmation
If you select Fa c to ry De fa ult, the following warning will appear.
Fig ure 390 Reboot System: Use the Factory Default Confirmation
If you select Custo m De fa ult, the following warning will appear.
Fig ure 391 Reboot System: Use the Custom Default Confirmation
2 Click O K again and then wait for the Switch to restart. This takes up to 2 minutes. This does not affect the
Switch’s configuration.