Chapter 63 Security
GS2220 Series User’s Guide
505
63.5 Co nfig ure SNMP Tra p G ro up
The Switch sends traps to an SNMP manager when an event occurs. From the SNMP screen, click Tra p
G ro up to view the screen as shown. Use the Tra p G ro up screen to specify the types of SNMP traps that
should be sent to each SNMP manager.
Fig ure 381 Security > Access Control > SNMP > Trap Group
Port Enter the port number upon which the manager listens for SNMP traps.
Username Enter the user name to be sent to the SNMP manager along with the SNMP v3 trap.
This user name must match an existing account on the Switch (configured in the Se c urity >
Ac c e ss C o ntro l > SNMP > Use r Info rm a tio n screen).
Apply Click Ap ply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Ca nc e l to begin configuring this screen afresh.
Table 269 Security > Access Control > SNMP > SNMP (continued)
LABEL DESC RIPTIO N
To Next Page
Loading...
