ZyXEL Communications GS2220 Series - LLDP Configuration Org-Specific TLV Setting

Chapter 36 Link Layer Discovery Protocol (LLDP)
GS2220 Series User’s Guide
333
36.6.2 LLDP C o nfig ura tion O rg - spe c ific TLV Se tting
Use this screen to configure organization-specific TLV settings. Click Adva nc e d Applic a tio n > LLDP > LLDP
Config ura tio n (Clic k He re ) > Org - spe c ific TLV Se tting to display the screen as shown next.
Fig ure 253 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
The following table describes the labels in this screen.
System Name Select the check boxes to enable or to disable the sending of System Name TLVs on the
ports.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click C a nc e l to begin configuring this screen afresh.
Table 167 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting (continued)
LABEL DESC RIPTIO N
Table 168 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
LABEL DESC RIPTIO N
Port This displays the Switch’s port number.
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Dot1 TLV
Port-Protocol
VLAN ID
Select the check boxes to enable or disable the sending of IEEE 802.1 Port and Protocol VLAN
ID TLVs on the ports.
Port VLAN ID Select the check boxes to enable or disable the sending of IEEE 802.1 Port VLAN ID TLVs on
the ports. All check boxes in this column are enabled by default.
Link
Aggregation
Select the check boxes to enable or disable the sending of IEEE 802.3 Link Aggregation TLVs
on the ports.
Dot3 TLV
MAC/PHY Select the check boxes to enable or disable the sending of IEEE 802.3 MAC/PHY
Configuration/Status TLVs on the ports. All check boxes in this column are enabled by default.
Max Frame Size Select the check boxes to enable or disable the sending of IEEE 802.3 Max Frame Size TLVs on
the ports.