Chapter 7 Status
GS2220 Series User’s Guide
97
7.2.1 Ne ig hbor Sc re e n
The Ne ig hb o r screen allows you to view a summary and manage the Switch’s neighboring devices. It
uses Layer Link Discovery Protocol (LLDP) to discover all neighbor devices connected to the Switch
including non-Zyxel devices. You can use this screen to perform tasks on the neighboring devices like
login, power cycle (turn the power off and then back on again), and reset to factory default settings.
This screen shows the neighboring device first recognized on an Ethernet port of the Switch. Device
information is displayed in gray when the neighboring device is offline.
Click Sta tus > Ne ig hbo r to see the following screen.
Hybrid Mode This field displays whether the Switch is in Sta nda lone mode or C lo ud mode. In Sta nda lo ne mode
you can see a link to a QR code to register the Switch to use NCC (Nebula Control Center).
Cloud Control
Status
This field displays the registration and connection status between the Switch and the NCC
(Nebula Control Center).
In Standalone mode, the status will display Disc o nne c te d or Unre g iste re d. In cloud mode the
status will display Co nne c te d or Disc o nne c te d.
Co nne c te d – The Switch is registered with and connected to the NCC.
Disc o nne c te d – The Switch is not connected to the NCC.
Unre g iste re d – The Switch is not registered with the NCC.
PoE Usage This field displays the amount of power the Switch is currently supplying to the connected PoE-
enabled devices and the total power the Switch can provide to the connected PDs. It also
shows the percentage of PoE power usage.
When PoE usage reaches 100%, the Switch will shut down PDs one-by-one according to the PD
priority which you configured in Ba sic Se tting > Po E Se tup .
Detail Click this link to go to the Ba sic Se tting > Syste m Info screen to check other detailed information,
such as system resource usage and the Switch temperature, fan speeds or voltage.
IP Address Information
IPv4 Address This field displays the Switch’s current IPv4 address.
Subnet Mask This field displays the Switch’s subnet mask.
Default
Gateway
This field displays the IP address of the Switch’s default gateway.
IP Setup Click the link to go to the Ba sic Se tting > IP Se tup screen.
IPV6 Global
Unicast Address
This field displays the Switch’s IPv6 global unicast address
IPV6 Link-Local
Address
This field displays the Switch’s IPv6 link-local address.
IPv6
configuration
Click the link to go to the Ba sic Se tting > IPv6 screen.
Device Status
and Quick
Configuration
This section shows whether a feature is enabled or not on the Switch. You can click a feature’s
Se tting link to go to the configuration screen for the feature.
Hover your cursor over a red exclamation mark to display information about the feature.
Quick Links This section provides the shortcut link to a specific configuration screen.
Table 22 Status (continued)
LABEL DESCRIPTIO N
To Next Page
Loading...
