ZyXEL Communications GS2220 Series - Page 98

Chapter 7 Status
GS2220 Series User’s Guide
98
Fig ure 79 Status > Neighbor
The following table describes the fields in the above screen.
Table 23 Status > Neighbor
LABEL DESC RIPTIO N
Port This shows the port of the Switch, on which the neighboring device is discovered.
Port Name This shows the port description of the Switch.
PD Health This shows the status of auto PD recovery on this port.
• Red: The Switch failed to get information from the PD connected to the port using LLDP,
or the connected PD did not respond to the Switch’s ping requests.
• Yellow: The Switch is restarting the connected PD by turning the power off and turning it
on again.
• Green: The Switch successfully discovered the connected PD using LLDP or ping.
• –: Auto PD Recovery is not enabled on the Switch and the port, or the Switch does not
supply power to the connected PD.
Note: The status will NOT be updated instantaneously after enabling or disabling
the Ac tive switch in the Adva nc e d Applic a tio n > Auto PD Re c ove ry screen.
It will wait until the configured Re sume Po lling Inte rva l (se c ) has lapsed.
Link This shows the speed (either 10M for 10 Mbps, 100M for 100 Mbps, or 1G for 1 Gbps) and the
duplex (F for full duplex or H for half). This field displays Down if the port is not connected to
any device.
PoE Draw (W) This shows the consumption that the neighboring device connected to this port draws from
the Switch. This allows you to plan and use within the power budget of the Switch.
System Name This shows the system name of the neighbor device.
IPv4 This shows the IPv4 address of the neighbor device. The IPv4 address is a hype r link that you
can click to log into and manage the neighbor device through its Web Configurator.
IPv6 This shows the IPv6 address of the neighbor device. The IPv6 address is a hype r link that you
can click to log into and manage the neighbor device through its Web Configurator.
PWR Cycle Click the C yc le button to turn OFF the power of the neighbor device and turn it back ON
again. A count down button (from 5 to 0) starts.
Note: The Switch must support power sourcing (PSE) or the network device is a
powered device (PD).