ZyXEL Communications GS2220 Series - Configure VLAN Port Settings

Chapter 9 VLAN
GS2220 Series User’s Guide
141
9.6 C o nfig ure VLAN Po rt Se tting s
Use this screen to configure the static VLAN (IEEE 802.1Q) settings on a port. Click the VLAN Po rt Se tup link
in the VLAN C o nfig ura tio n screen.
Fig ure 115 Advanced Application > VLAN > VLAN Configuration > VLAN Port Setup
Add Click Add to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Ca nc e l to begin configuring this screen afresh.
Clear Click Cle a r to start configuring the screen again.
VID This field displays the ID number of the VLAN group. Click the number to edit the VLAN settings.
Active This field indicates whether the VLAN settings are enabled (Ye s) or disabled (No ).
Name This field displays the descriptive name for this VLAN group.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Click De le te to remove the selected entry from the summary table.
Cancel Click Ca nc e l to clear the check boxes.
Table 52 Advanced Application > VLAN > VLAN Configuration > Static VLAN Setup (continued)
LABEL DESCRIPTIO N