Chapter 21 Classifier
GS2220 Series User’s Guide
214
21.5 Cla ssifie r Exa mple
The following screen shows an example where you configure a classifier that identifies all traffic from
MAC address 00:50:ba:ad:4f:81 on port 2.
Active Select this to allow the Switch to create a log when packets match a classifier rule during a defined
time interval.
Interval Select the length of the time period (in seconds) to count matched packets for a classifier rule. Enter
an integer from 0 – 65535. 0 means that no logging is done.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these changes if it
is turned off or loses power, so use the Sa ve link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Cancel Click Ca nc e l to begin configuring this screen afresh.
Table 93 Advanced Application > Classifier > Classifier Configuration > Classifier Global Setting
LABEL DESC RIPTIO N
To Next Page
Loading...
