Chapter 24 Multicast
GS2220 Series User’s Guide
239
24.4.5 MLD Sno o ping - pro xy Filte ring Pro file
Use this screen to create an MLD filtering profile and set the range of the multicast addresses. Click the
Filte ring Pro file link in the Adva nc e d Applic a tio n > Multic a st > IPv6 Multic a st > MLD Snoo ping - pro xy >
Filte ring screen to display the screen as shown.
Fig ure 183 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering >
Filtering Profile
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Group Limit Select this option to limit the number of multicast groups this port is allowed to join.
Max Group Num. Enter the number of multicast groups this port is allowed to join. Once a port is registered in
the specified number of multicast groups, any new MLD Report message is dropped on this
port.
Filtering Profile Select the name of the MLD filtering profile to use for this port. Otherwise, select De fa ult to
prohibit the port from joining any multicast group.
You can create MLD filtering profiles in the Multic a st > IPv6 Multic a st > MLD Sno o ping - pro xy
> Filte ring > Filte ring Pro file screen.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click C a nc e l to reset the fields to your previous configuration.
Table 105 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
LABEL DESCRIPTIO N
To Next Page
Loading...
