Chapter 17 Link Aggregation
GS2220 Series User’s Guide
189
The following table describes the labels in this screen.
17.3 Link Ag g re g a tio n Se tting
Click Adva nc e d Applic a tio n > Link Ag g re g a tio n > Link Ag g re g a tion Se tting to display the screen shown
next. See
Section 17.1 on page 187 for more information on link aggregation.
Table 78 Advanced Application > Link Aggregation Status
LABEL DESC RIPTIO N
Group ID This field displays the group ID to identify a trunk group, that is, one logical link containing multiple
ports.
Enabled Ports These are the ports you have configured in the Link Ag g re g a tio n screen to be in the trunk group.
The port numbers displays only when this trunk group is activated and there is a port belonging to
this group.
Synchronized
Ports
These are the ports that are currently transmitting data as one logical link in this trunk group.
Aggregator ID Link Aggregator ID consists of the following: system priority, MAC address, key, port priority and
port number.
The ID displays only when there is a port belonging to this trunk group and LACP is also enabled
for this group.
Criteria This shows the outgoing traffic distribution algorithm used in this trunk group. Packets from the
same source and/or to the same destination are sent over the same link within the trunk.
src - ma c means the Switch distributes traffic based on the packet’s source MAC address.
dst- m a c means the Switch distributes traffic based on the packet’s destination MAC address.
src - dst- m a c means the Switch distributes traffic based on a combination of the packet’s source
and destination MAC addresses.
src - ip means the Switch distributes traffic based on the packet’s source IP address.
dst- ip means the Switch distributes traffic based on the packet’s destination IP address.
src - dst- ip means the Switch distributes traffic based on a combination of the packet’s source
and destination IP addresses.
Status This field displays how these ports were added to the trunk group. It displays:
• Sta tic – if the ports are configured as static members of a trunk group.
• LAC P – if the ports are configured to join a trunk group through LACP.
To Next Page
Loading...
