Chapter 9 VLAN
GS2220 Series User’s Guide
137
802.1Q Sta tic VLAN
Make sure 802.1Q is selected in the Ba sic Se tting > Switc h Se tup screen.
Use a static VLAN to decide whether an incoming frame on a port should be
• sent to a VLAN group as normal depending on its VLAN tag.
• sent to a group whether it has a VLAN tag or not.
• blocked from a VLAN group regardless of its VLAN tag.
You can also tag all outgoing frames (that were previously untagged) from a port with the specified
VID.
9.3 VLAN Sta tus
Use this screen to view and search all static VLAN groups. Click Adva nc e d Applic a tio n > VLAN from the
navigation panel to display the VLAN Sta tus screen as shown next.
Fig ure 111 Advanced Application > VLAN: VLAN Status
The following table describes the labels in this screen.
Table 49 Advanced Application > VLAN: VLAN Status
LABEL DESC RIPTIO N
VLAN Search by
VID
Enter (an) existing VLAN ID numbers (use a comma (,) to separate individual VLANs or a dash (–)
to indicate a range of VLANs. For example, “3,4” or “3–9”) and click Se a rc h to display only the
specified VLANs in the list below.
Leave this field blank and click Se a rc h to display all VLANs configured on the Switch.
The Number of
VLAN
This is the number of VLANs configured on the Switch.
The Number of
Search Results
This is the number of VLANs that match the searching criteria and display in the list below.
This field displays only when you use the Se a rc h button to look for certain VLANs.
Index This is the VLAN index number. Click an index number to view more VLAN details.
VID This is the VLAN identification number that was configured in the corresponding VLAN
configuration screen.
Name This fields shows the descriptive name of the VLAN.
To Next Page
Loading...
