Chapter 9 VLAN
GS2220 Series User’s Guide
136
Fig ure 109 Port VLAN Trunking
9.2.0.3 VLAN Prio rity
At the time of writing, you can create Static VLANs, Voice VLANs, Vendor ID-based VLANs, Subnet Based
VLANs, Protocol Based VLANs and MAC Based VLANs on the Switch when the VLAN type is set to 802.1Q.
When a packet is received, the Switch processes the VLAN rules in sequence. The sequence (priority) of
the VLANs is:
1 Vendor ID Based VLAN
2 Voice VLAN
3 Subnet Based VLAN
4 Protocol Based VLAN
5 MAC Based VLAN
If the packet matches a VLAN rule that has a higher priority, for example, an entry with weight 250 in the
vendor ID to VLAN mapping table, the Switch assigns the corresponding VLAN ID to the packet and
stops checking the subsequent VLAN rules.
9.2.0.4 Se le c t the VLAN Type
Select a VLAN type in the Ba sic Se tting > Switc h Se tup screen.
Fig ure 110 Basic Setting > Switch Setup > Select VLAN Type
To Next Page
Loading...
