ZyXEL Communications GS2220 Series - Ipv6 Multicast Status; MLD Snooping-Proxy

GS2220 Series User’s Guide
234
24.4 IPv6 Multic a st Sta tus
Click Adva nc e d Applic a tio n > Multic a st > IPv6 Multic a st to display the screen as shown. This screen
shows the IPv6 multicast group information. See
Section 24.1 on page 223 for more information on
multicasting.
Fig ure 178 Advanced Application > Multicast > IPv6 Multicast
The following table describes the fields in the above screen.
24.4.1 MLD Sno o ping - pro xy
Click the MLD Snooping - pro xy link in the Adva nc e d Applic a tio n > Multic a st > IPv6 Multic a st screen to
display the screen as shown. See
Section 24.1 on page 223 for more information on multicasting.
Fig ure 179 Advanced Application > Multicast > IPv6Multicast > MLD Snooping-proxy
The following table describes the fields in the above screen.
Table 101 Advanced Application > Multicast > IPv6 Multicast
LABEL DESC RIPTIO N
Index This is the index number of the entry.
VID This field displays the multicast VLAN ID.
Port This field displays the port number that belongs to the multicast group.
Multicast Group This field displays IP multicast group addresses.
Group Timeout This field displays the time (in seconds) that elapses before the Switch removes a MLD group
membership entry if it does not receive report messages from the port.
Table 102 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy
LABEL DESC RIPTIO N
MLD Snooping-proxy Use these settings to configure MLD snooping-proxy.
Active Select Ac tive to enable MLD snooping-proxy on the Switch to minimize MLD control
messages and allow better network performance.
802.1p Priority Select a priority level (0 – 7) to which the Switch changes the priority in outgoing MLD
messages.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Sa ve link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Ca nc e l to begin configuring this screen afresh.