ZyXEL Communications GS2220 Series - Page 233

Chapter 24 Multicast
GS2220 Series User’s Guide
233
Fig ure 177 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Filtering Profile
The following table describes the labels in this screen.
Table 100 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Filtering Profile
LABEL DESC RIPTIO N
Profile Name Enter a descriptive name for the profile for identification purposes.
To configure additional rules for a profile that you have already added, enter the profile
name and specify a different IP multicast address range.
Start Address Type the starting multicast IP address for a range of multicast IP addresses that you want to
belong to the IGMP filter profile.
End Address Type the ending multicast IP address for a range of IP addresses that you want to belong to
the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both the Sta rt Addre ss and End
Add re ss fields.
Add Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Sa ve link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Clear Click C le a r to reset the fields to the factory defaults.
Profile Name This field displays the descriptive name of the profile.
Start Address This field displays the start of the multicast address range.
End Address This field displays the end of the multicast address range.
Delete Profile Select a profile’s check box to select a specific profile. Otherwise, select the check box in the
table heading row to select all profiles.
Delete Rule Select the check boxes of the rules that you want to remove from a profile.
Delete To delete the profiles and all the accompanying rules, select the profiles that you want to
remove in the De le te Profile column, then click the De le te button.
To delete a rules from a profile, select the rules that you want to remove in the De le te Rule
column, then click the De le te button.
Cancel Click Ca nc e l to clear the De le te Pro file or De le te Rule check boxes.