Chapter 3 Hardware Panels
GS2220 Series User’s Guide
44
Fig ure 24 Combo Port Example: Gigabit Port and SFP Transceiver Slot
3.1.5 C o nso le Po rt
This console port is for troubleshooting only. With instructions from customer support, connect the male 9-
pin end of the RS-232 console cable to the console port of the Switch. Connect the female end to a
serial port (COM1, COM2 or other COM port) of your computer. You can use a computer with terminal
emulation software configured to the following parameters:
• VT100 terminal emulation
• 115200 bps
• No parity, 8 data bits, 1 stop bit
• No flow control
3.2 Re a r Pa ne l
The following figures show the rear panels of the Switch. The rear panels contain:
Fig ure 25 Rear Panel: GS2220-10
Fig ure 26 Rear Panel: GS2220-10HP
Fig ure 27 Rear Panel: GS2220-28
Fig ure 28 Rear Panel: GS2220-28HP
To Next Page
Loading...
