ZyXEL Communications GS2220 Series - Erase Running-Configuration; Save Configuration; Reboot System

Chapter 46 Maintenance
GS2220 Series User’s Guide
389
46.2.1 Era se Running - Co nfig ura tion
Follow the steps below to clear current configuration on the Switch. This will reset the Switch back to its
factory defaults. Or, click the Fa c to ry De fa ult button in Re bo o t Syste m .
1 In the Ma inte na nc e screen, click the Clic k He re button next to Era se Running - C o nfig ura tio n to clear all
Switch configuration information you configured and return to the Zyxel default configuration settings.
2 Click OK to reset all Switch configurations to the Zyxel default configuration settings.
Fig ure 297 Erase Running-Configuration: Confirmation
3 In the Web Configurator, click the Sa ve button in the top of the screen to make the changes take
effect. If you want to access the Switch Web Configurator again, you may need to change the IP
address of your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1
or DHCP-assigned IP).
46.2.2 Sa ve C o nfig ura tio n
Click Co nfig 1 to save the current configuration settings permanently to Co nfig ura tio n 1 on the Switch.
These configurations are set up according to your network environment.
Click Co nfig 2 to save the current configuration settings permanently to Co nfig ura tio n 2 on the Switch.
These configurations are set up according to your network environment.
Click C usto m De fa ult to save the current configuration settings permanently to a customized default file
on the Switch. If configuration changes cause the Switch to behave abnormally, click Custo m De fa ult
(next to Re bo o t Syste m) to have the Switch automatically reboot and restore the saved Custo m De fa ult
configuration file.
Note: If a customized default file was not saved, clicking Custo m De fa ult loads the factory
default configuration on the Switch.
Alternatively, click Sa ve on the top right-hand corner in any screen to save the configuration changes
to the current configuration.
Note: Clicking the Apply or Add button does NOT save the changes permanently. All
unsaved changes are erased after you reboot the Switch.
46.2.3 Re b o o t Syste m
Re bo o t Syste m allows you to restart the Switch without physically turning the power off. It also allows you
to load configuration one (C onfig 1), configuration two (C o nfig 2), a C ustom De fa ult or the Fa c tory
De fa ult configuration when you reboot. Follow the steps below to reboot the Switch.