ZyXEL Communications GS2220 Series - Anti-Arpscan Configure

GS2220 Series User’s Guide
342
The following table describes the fields in the above screen.
37.5 Anti- Arpsc a n C o nfig ure
Use this screen to enable Anti- Arpsc a n, set port and host thresholds as well as configure ports to be
trusted or untrusted. To open this screen, click Adva nc e d Applic a tio n > Anti- Arpsc a n > Config ure .
Fig ure 260 Advanced Application > Anti-Arpscan > Configure
Table 174 Advanced Application > Anti-Arpscan > Trust Host
LABEL DESC RIPTIO N
Name Type a descriptive name of up to 32 printable ASCII characters to identify this host.
Host IP Type the IP address of the host.
Mask A trusted host may consist of a subnet of IP addresses. Type a subnet mask to create a
single host or a subnet of hosts.
Add Click this to create the trusted host.
Cancel Click this to reset the values above.
Clear Click this to clear the fields above.
Index This field displays a sequential number for each trusted host.
Name This field displays the name of the trusted host.
Host IP This field displays the IP address of the trusted host.
Mask This field displays the subnet mask of the trusted host.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Delete Select an entry check box and click De le te to remove the specified entry.
Cancel Click this to clear the check boxes above.